Automate 410 Guia de Instalação descarregar pdf (Página 11)

When the system receives the transmitter code controlling Channel 2 for longer than 1.5 seconds, the RED/WHITE

wire will supply an output as long as the transmission continues. This is often used to operate a trunk/hatch

release or other relay-driven functions.

IMPORTANT! Never use this wire to drive anything but a relay or a low-current input! The transis-

torized output can only supply 200 mA of current. Connecting directly to a solenoid, motor, or other

high-current device will cause it to fail.

plug-in LED and valet/program switch

The LED and the Valet/Program switch both plug into the control module. The status LED plugs into the small

two-pin port, while the Valet

/Program switch should be plugged into the larger blue two-pin port. The status

LED and Valet

/Program switch each fit into

/32-inch holes.

Status LED Valet

/Program Switch

H1/12 RED/WHITE channel 2, 200mA (-) output

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Sem comentários

Automate 410 Guia de Instalação Página 11