Automate AM1.5 Guia de Instalação descarregar pdf (Página 26)

internal programming jumper

A 10A fuse is used as both a fuse and a program jumper. This jumper determines the

light flash output polarity. In the (+) position, the on-board relay is enabled and the

unit will output (+)12V on the WHITE wire, H1/2. In the (-) position, the on-board

relay is enabled for (-) output on the WHITE wire, H1/2. To access the jumper, remove

the sliding door from on top of the control module, as shown below.

zones

NNOOTTEE::

The Warn Away

response does not report on the LED.

Zone

Number

Trigger Type Input Description

1 Instant trigger Hood and/or trunk pin switches.

2 Multiplexed input Heavy impact from on-board

Doublegurard

shock sensor.

3 Two-stage, progresses from warning

to full alarm

Door switch circuit.

4 Multiplexed Optional sensor, Inputs shorter than

0.8 seconds will trigger Warn Away

response, while inputs longer than

0.8 seconds will instantly trigger full

alarm.

5 Two-stage (similar to zone 3) Ignition input.

FUSE/JUMPER

(-) POSITION

FUSE/JUMPER

(+) POSITION

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 38 39

Sem comentários

Automate AM1.5 Guia de Instalação Página 26