Automate AM2 Guia de Instalação descarregar pdf (Página 15)

2003

Directed Electronics, Inc.

Single Button Lock (Arm)/Unlock (Disarm) Configuration

When programmed for single button lock (arm)/unlock (disarm) configuration using the Channel

7 Auto-learn configuration, the transmitter buttons are assigned to the following functions:

operates Lock (Arm)/Unlock (Disarm)/Panic

operates Channel 2 and Silent Mode

and operate Channel 3

Rapid Resume Logic

Rapid Resume Logic ensures that the when the system is powered up it will return to the same state

it was in when power is disconnected. For a full description of Rapid Resume Logic refer to the

owner's manual.

Master Dealer Remotes

A master dealer remote can be programmed into the system for demonstration purposes. Generally,

each salesman would carry a remote that would operate all the cars on the lot equipped with this

system. The dealer remotes are binary transmitters that are detuned slightly in order to limit trans-

mitting range. The dealer remote can be taught to the system by following the Transmitter Learn

Routine.

When installing the system, it is possible to preset all of the operation settings using the master

dealer remote. However, when the system is operated using the master dealer remote, a special set

of dealer default settings are followed. The dealer default settings are used to ensure that every

vehicle equipped with this system is protected at all times. Only the settings listed below are

affected. When using a master dealer remote, the system operates as follows:

➤➤

Passive locking (arming)

➤➤

Confirmation honks on

➤➤

Ignition lock and unlock on

➤➤

Passive locking

➤➤

Ignition domelight on

➤➤

Security features on

1 2 ... 10 11 12 13 14 15 16 17 18

Sem comentários

Automate AM2 Guia de Instalação Página 15